Protected stone with its natural color kept
Travertine Sealing in Hilliard, FL
Call (904) 980-0807 for a free travertine sealing estimate on Hilliard pool decks, patios and walkways.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can someone seal my travertine in Hilliard, and how soon will I hear back?
Yes, a local contractor can seal travertine at your Hilliard, FL home, and a reply comes within 1 business day, usually much sooner. The estimate costs nothing and the decision stays with you. To start, call (904) 980-0807.
Travertine is a soft, pitted stone, and it drinks water, oil and pool chemicals unless it is sealed. A stone-safe wash and the right sealer keep the cream and tan tones from going blotchy. Tell the contractor where the stone sits and how it is used when you send in the short form, and the plan can be matched to it.
Why does travertine need a different sealer than concrete pavers?
Travertine is a sedimentary rock made of calcium carbonate, and a Florida paver company calls it porous. Wikipedia puts the porosity of fresh travertine anywhere from about 10 to 70 percent, and its surface often shows pitted holes and troughs. Water, oil and pool chemicals all find a way in. Ask how the contractor will treat those pits when you send in the short form.
A concrete paver can wear a film-forming coat that sits on the face. On stone, a Fort Lauderdale paver company says that kind of coat can peel, blister or leave a white haze, and it recommends a penetrating impregnator that soaks in without leaving a layer. The product name belongs in your written quote. If it is missing, call (904) 980-0807 and ask for it.
What does a travertine sealing visit in Hilliard cover?
Four things happen in order, and the order matters more than the brand on the jug. A contractor can walk you through each one at your own house when you call (904) 980-0807.
Look at the stone
The contractor checks for chips, loose pieces, low spots, old film sealer and marks that have soaked in, then measures the area.
Gentle clean
Stone-safe cleaning products and low pressure lift pollen, mildew and grime without scarring the face.
Dry time
Stone must be dry through and through before a coat goes on, which in a shaded Hilliard lanai can take longer than a sunny driveway.
Impregnator
The penetrating sealer is worked in evenly and the excess is wiped off before it can dry as a film.
Can travertine be pressure washed before it is sealed?
Not like a concrete driveway. A Fort Lauderdale paver company says the 2,500 to 3,000 PSI many homeowners and washers use can erode travertine, so its crews work at 800 to 1,200 PSI with hot water. Soft stone scars once, and a scar stays. Ask which pressure and which cleaner will touch your stone when you send in the short form.
Acid is the other hazard. Wikipedia explains that carbonic acid dissolves calcium carbonate, the same material that makes up travertine, so a strong acid cleaner can etch the surface and leave dull spots. Rust and mineral marks need a product made for stone. To ask a contractor what that looks like for yours, call (904) 980-0807.
How long will a coat on travertine last near Hilliard?
A Florida paver company says pool decks need resealing about every 2 to 3 years, while patios and walkways can go 3 to 5. A Northeast Florida price guide gives 3 to 5 years for most paved areas and shorter for pool decks. Chlorine, sun and rain all wear on a coat, and Nassau County gets about 49 inches of rain a year. To set a recheck date, call (904) 980-0807.
Your own stone will tell you when it is time. The same Florida company lists four signs: water that no longer beads, a faded or dull look, stains that resist cleaning and a surface that feels slicker than before. For a quick opinion on yours, send in the short form.
When is the right time of year to seal travertine in Hilliard?
A Fort Lauderdale paver company names March through May and October through November as its best windows, and warns that heat waves raise surface temperature and cause uneven absorption and patchy spots. In Nassau County the wettest month is September, with 6.91 inches, and the driest is November, with 2.08. That makes late fall a calm choice, and the Northeast Florida washing company that lists fall as its favorite season agrees. To plan a date around the forecast, send in the short form.
Spring has a catch of its own. UF/IFAS says tree pollen peaks in March and April, and pine pollen settles as yellow dust on pale stone. A careful wash right before the coat takes it off. Mention your calendar when you call (904) 980-0807.
Can pool chemicals and well water mark my travertine?
They can both leave a trace. A Florida paver company says sealer keeps chlorine, salt and other chemicals from working into the stone, and a Northeast Florida washing company says iron in well water leaves orange stains on concrete, garage doors and stucco. Pale stone shows rust more than most surfaces, and added pressure makes it worse. Point out any orange spots when you send in the short form.
Sprinklers matter wherever the water carries iron. If the heads spray the lanai, the iron lands on the stone every cycle. A contractor can suggest a sealed surface plus a rust treatment, or a change to where the spray falls. To talk it through, call (904) 980-0807.
Is honing or polishing the same as sealing?
No. Honing and polishing change how the stone face looks, and a company with a Hilliard page lists stone honing, polishing, cleaning and sealing as separate services, travertine among them. Sealing is protection after the face is where you want it. If the stone has deep etching or scratches, ask whether a repair step comes first. To raise it at the estimate, send in the short form.
Where around a Hilliard home does travertine get sealed?
Travertine turns up on pool decks, lanai floors, entry courts, steps and walkways, and each place weathers differently. Choose the area that bothers you most and start there. To have it looked at, call (904) 980-0807.
Pool decks
Wet feet, chlorine and sun. A non-slip additive is worth asking about, since a Fort Lauderdale paver company adds one on pool decks.
Lanai floors
Shade holds damp in the pits and the joints, which means mildew shows first on the shaded side.
Entry courts and steps
Soil from planting beds and drips from pots darken stone near the front door.
Walkways
Long runs through pine and oak cover collect needles and pollen, and wet leaves can stain.
What does travertine sealing cost in Hilliard?
No page lists one price for travertine sealing in Hilliard, so the numbers below are built from published pieces. One Northeast Florida company starts travertine at $1.60 per square foot and concrete or brick pavers at $1.50. Another price guide says stone and brick run 15 to 30 percent above standard concrete paver work and warns that bids under $1 per square foot usually skip prep. For a number on your own stone, send in the short form.
Stripping failed sealer adds money, and so does a deep clean. A Fort Lauderdale paver company lists $1.00 to $2.00 per square foot for sealing there, with jobs that need deep cleaning or old sealer removal at the high end. Small jobs cost more per foot than large ones, as the Northeast Florida guide shows. Compare a written quote with these figures, and call (904) 980-0807 if it looks far outside them.
| Stone area | Typical example | Concrete paver rate | Travertine, with 15 to 30 percent added |
|---|---|---|---|
| 200 sq ft | Small entry court or walk | $350 to $650 | $402 to $845 |
| 400 sq ft | Lanai floor or patio | $700 to $1,300 | $805 to $1,690 |
| 700 sq ft | Pool deck | $1,225 to $2,275 | $1,409 to $2,958 |
| 1,100 sq ft | Pool deck with a wide lanai | $1,925 to $3,575 | $2,214 to $4,648 |
No page gives one rate for travertine sealing alone in Northeast Florida, so this table is built from pieces that are published. The third column multiplies the $1.75 to $3.25 per square foot that a Northeast Florida washing company lists for clean, sand and seal. The fourth adds the 15 to 30 percent that a Northeast Florida price guide says travertine, natural stone and brick cost above standard concrete paver work. The figure on your own quote comes from the contractor after a look at the surface.
What if the wrong sealer is already on my stone?
It can be taken off. A Florida paver company says the wrong product may need stripping and resealing by a professional, and a Fort Lauderdale company says failed film must be stripped before a new coat, which adds labor. A cloudy or peeling coat on stone is the usual sign. Ask for a small test spot before the whole floor is stripped, and send in the short form.
Which places in Nassau County get travertine sealing visits?
A contractor who works near Hilliard covers the towns below across Nassau County and nearby counties, and each one has its own page. If your street is not listed, a call to (904) 980-0807 will settle it.
What does sealed stone look like near Hilliard?
How does the travertine sealing process run from start to finish?
The process takes one to two days, mostly because stone has to dry. Day one is the look-over, the gentle wash and the wait. Day two is the sealer and the wipe-down, and the contractor tells you how long to keep feet and furniture off. To pick a date, call (904) 980-0807.
Questions Hilliard homeowners ask about travertine sealing
Is it good to seal pavers in Florida?
For travertine, yes in most cases. A Florida paver company says unsealed travertine soaks up water and stains faster in Florida heat, humidity and rain, and that sealer keeps pool chemicals and salt from working into the stone. The stone stays usable without a coat, but marks and fading show up sooner.
How much does it cost to seal travertine pavers?
Published figures run from about $1.60 per square foot as a starting rate for travertine at one Northeast Florida company to $1.75 to $3.25 per square foot for a full clean, sand and seal at another. A Northeast Florida price guide says stone work costs 15 to 30 percent more than concrete pavers. A 400 square foot lanai would land near $800 to $1,700 at those rates.
Which sealant is right for travertine tiles?
A penetrating stone impregnator, according to a Fort Lauderdale paver company, which warns that film-forming sealers can peel, blister or leave a white haze on travertine. A Florida stone company also lists enhancing and water-based types. Pool decks get a non-slip additive. Your contractor should name the product before the work starts.
Which paver sealer works for Florida pavers?
It depends on the surface. Concrete and brick pavers take penetrating or film-forming coats, and a Northeast Florida price guide says film-forming ones give the wet look at a higher price. Natural stone such as travertine does better with a penetrating product. The label on the can sets the coverage rate.
How often does travertine need to be resealed in Florida?
One Florida paver company says pool decks about every 2 to 3 years and patios and walkways every 3 to 5. Water that no longer beads, dull color, stains that will not wash out and a surface that feels slicker than before all mean the coat is spent.
Can travertine be pressure washed before sealing?
Not at the settings used on a concrete driveway. A Fort Lauderdale paver company says standard residential pressure of 2,500 to 3,000 PSI can erode travertine, and it works at 800 to 1,200 PSI with stone-safe cleaning products instead.
Does travertine get too hot for bare feet around a Hilliard pool?
It stays cooler underfoot than most surfaces, a Florida paver company says, which is why it is common around pools. Pale stone also shows pine pollen, which UF/IFAS says lays on thick as yellow dust each March and April, so a rinse in spring keeps the look clean.
Will the soft sandy ground near Hilliard affect a travertine patio?
It can. Nassau County's flatwoods soil is sand, and USDA describes the Kingsferry series as poorly drained with a water table within 12 inches of the surface for two to six months. A stone that rocks or sits low needs its base fixed before any sealer, because a coat does not lift a sunken paver.
Other paver services in Hilliard
Travertine is one part of the yard. Driveways, brick, patios and stained pavers each have a page. Questions about any of them? Call (904) 980-0807.
Ready for a free travertine sealing estimate in Hilliard?
Phone in or use the short form. Expect an answer from a local contractor inside 1 business day, usually much sooner, then choose a date that suits your yard.
Free, no obligation